Menvier Security TS2500 Guia do Utilizador descarregar pdf (Página 3)

Introduction

The TS2500 intruder alarm control system has been

designed to suit medium to large installation sites. The

TS2500 system can be expanded up to 1040 zones.

The system is capable of “up” and “down” loading,

allowing remote programming and interrogation via

the telephone line and a P.C.

Complex site requirements such as multi-ward setting

can be achieved, as the system is capable of being

broken down into 16 separately controlled areas

(Wards) so that the premises or parts of the premises

can be controlled independently.

The TS2500 system is a true multi-tasking system, which

allows up to a maximum of eight users operating the

system simultaneously.

Control Panel

The control panelis thecontrolling unitfor thesystem, it

has a power supply and connections for a standby

battery. It has the following facilities:

8 networks for connecting remote keypads and

NODEs

Connections for two 8 zone local expansion cards

(LEC8)

l Two auxiliary tamper zones

Bell and strobe outputs

4 programmable outputs (1 x Voltage free

contacts and 3 high current transistorised)

8 programmable digicom/RedCARE outputs

A connector for a Menvier Security plug-on

digicom or digi-modem

A connector for a printer via the MPA or DCI printer

adaptor

A connector for mimic modules (CPA6.OM)

Extension loudspeaker output

All system program information and the 4000

event log is stored in two removable non-volatile

memory (NVM) devices

Remote Keypads

Up to 5 remote keypads can be connected when

directly wired to the network. The XNODE also provides

thefacility to connect up to 4 remote keypads giving a

system total of 512 remote keypads. Each remote

keypad has two detection circuits and a single

switched -ve output. The four types are:

32 Character LCD (NETLCD)

TheNETLCDremotekeypadhasaback-lit32character

super-twist Liquid Crystal Display (LCD) and a back-lit

tactilerubberkeypad.Italso hasaLoudspeaker output

with a volume control pot. All system programming

must be carried out from a NETLCD remote keypad.

8 Character Starburst (NETSTAR)

The NETSTAR remote keypad has a back-lit 8 character

starburst display (LCD) and a back-lit tactile rubber

keypad. This type of remotekeypad is limited to setting

and unsetting only, and cannot be used to program

the system.

☞

The display will always show the system time.

4 Character LED (NETLED)

The NETLED remote keypad has a 4 character

7-segment LED display and back-lit tactile rubber

keypad. This type of remotekeypad is limited to setting

and unsetting, and cannot be used to program the

system.

☞

The display will always show the system time.

Remote Arming Station (NETARM)

The Remote Arming Station only allows setting and

unsettingofthesystem. TheunithastwoindicatorLED’s,

the “Power LED” and a programmable “Function LED”

(the “Function LED” may be programmed as “Fault” or

“Area Set” etc.).

496513 Issue A 3of26 TS2500

TS2500

1 2 3 4 5 6 7 8 ... 25 26

Comentários a estes Manuais

Sem comentários

Menvier Security TS2500 Guia do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Menvier Security TS2500