Menvier Security TS700 Manual de Instruções descarregar pdf (Página 10)

Installing a Plug-on Digicom

1. A digicom type DC54 or DC58 can be fitted in the base of the TS700 main panel. The unit

should be fitted in accordance with the i nstallati on instruc tions supplied with it and

connected to JP3.

2. The alarm channels for the plug-on digicom a re programmed as required (page 16). It will

be necessary to fit a programmed NVM in the digicom or to program it in accordance with

the instructions supplied with the unit.

Installing a stand-alone Digicom or RedCARE

A stand-alone digital communicator, Red CARE STU or Paknet interface card can be connected

tothesystemtotrans ferpanelalarmstatusinformationtoa dedicatedalarmreceivingcentre.The

control panel has the following conne ctions (Figure 6) for a digicom etc.

1 to 8 - These are the programmabledigicom outputs. They are norm ally at+ 12V

and switch to 0V when active.

+DC POWER - This provides a permanent +12V power to the digicom. The output is

un-fused a nd therefore should only be used if the digicom is fitted inside

the control panel.

LINE FLT - When this input is switched to +12V a telephone line fault condition will be

generated.

REM RESET - Ifth e system is programmed for“Engineer Reset”,t hen after a fullalarm the

system wi llrequireresetting, norma llythis is done bythe e ngineer orcoded

remote reset. Applying a -ve to th is input terminal will cause the system to

reset after a full alarm. This input could be connected to the “Control”

output on a RedCARE STU s o that the Alarm Receiving Centre can poll the

STU and thus reset the panel.

System Ins tallation TS700 Installation Manual

Control

Panel

3GSTU

+DC POWER

Program

As:-

Open (08)

Alarm (05)

PA (06)

Fire (07)

LINE FLT

AUX 0V

TB1

Channel Inputs are

Progr ammed as

Positive Removed

TB2

TB3

TB4

Control

Line

Fault RPS

NO NO NONC NC NC

C CC

A+ A+ A+ A+ V+

Figure 6. 3GSTU RedCAR E Connections

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comentários a estes Manuais

Sem comentários

Menvier Security TS700 Manual de Instruções Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Menvier Security TS700