Menvier Security TS400 Manual de Instruções descarregar pdf (Página 6)

The TSD402 incorporates a 3 button set facility which simplifies the setting and part-setting

of the system for user. When the user wishes to full set the system, they simply enter the first

2 digits of their passcode followed by the AWAY key. To part-set the system, they simply

enter the first 2 digits of their passcode followed by the HOME key. When unsetting the

system the user must enter all 4 digits of the passcode.

Speech Dialler Operation

The speech dialler may be configured by the engineer to trigger on FIRE, P.A. or ALARM

activations for both the Away set and Home set. In addition to alarm triggers provided

internally from the control panel, there are 3 auxiliary inputs which may be used by other

devices to trigger the speech dialler independently from that of the control panel.

Telephone

Numbers

- The TSD402 stores up to three different telephone numbers. Each

number may be up to 16 digits long and are simply

programmed using the text display and keypad on the unit. The

unit is compatible with most PABX systems that require a pause

or wait for secondary dial tone. Note: The Emergency Service

numbers (999 &112) cannot be programmed into the unit.

Messages - The TSD402 has a built-in microphone and speaker so that

phrases can be recorded and replayed directly from the unit. A

message is formed by combining a common phrase (0) and

one of the alarm phrases (F, P or A). When the out-going call is

answered the unit plays the common phrase (0) and one of the

three alarm phrases F, P or A. Phrase 0 states the name and

address of the user and phrases F, P and A relate to the alarm

type (FIRE ,PA, ALARM). There is 60 seconds of recording time

available for phrases and each phrase can be any length as

long as the total does not exceed 60 seconds. For example, the

"Common Phrase" may be 12 seconds, "Phrase F" 5 seconds,

"Phrase P" 8 seconds and "Phrase A" 7 seconds.

Reporting Options - Each alarm type (F, P or A) may be programmed to report only

to selected telephone numbers. For example the Fire activation

may be programmed to report to all three telephone numbers,

whereas the Alarm activation may be programmed to report

only to telephone numbers 1 and 3 etc.

Call

Acknowledgement

- When the call is answered, the message is played. At the end of

the message the unit sends an audible "bleep" which must be

answered within 2 seconds using the tone generated by pressing

the number [8] button on a standard telephone. On hearing the

[8] tone the unit immediately sends a second "bleep" which must

be answered in the same way. If successful, a multi-tone

confirmation signal is then heard, if not then the message is

Overview TSD402 Installation Manual

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentários a estes Manuais

Sem comentários

Menvier Security TS400 Manual de Instruções Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Menvier Security TS400